2001 Arctic Cat ATVs factory service and repair manual, Page 44Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 44

Place the shift lever in the "Reverse" positionThe reverse gear indicator light should illuminate ! WARNING Never shift the
both the shift select arm and shift lever in the neutral position, adjust the front and rear jam nuts using two 34 inopen-end
wrenchesNOTE: Adjust the jam nuts until the cable eye can be installed on the shift select arm without moving the shift lever
or the shift select arm out of the neutral position 733-707B blue light will illuminate when the lights are on high beamThe
light will not be illuminated when the lights are switched to low beam red light will illuminate if the engine overheatsThe
light should be off during normal operation 5Secure the cable to the shift select arm with the existing E-ring6Tighten the
front and rear jam nuts to secure the adjustmentNOTE: At this point the lever should be adjusted correctlyIf the indicator
light does not illuminate, troubleshoot the other possible reasons! CAUTION Continued operation of the ATV with high engine