2001 Arctic Cat ATVs factory service and repair manual, Page 45Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 45

GEAR POSITION LIGHTS (300 cc 4x4 400500 ccManual Transmission) Fig2-89 FrameWeldsRacks The frame, welds, and racks should
engine emperature Decreasing engine RPM, reducing load, and selecting an appropriate transmission gear can lower the temperatureNOTE:
Debris in front of the engine (or packed between the cooling fins of the radiator on the 400 500 cc or packed between the
oil cooler cooling fins on the 300 cc) can reduce cooling capabilityUsing hose, pressure-wash the radiator (engine and oil
cooler on the 300 cc) to remove any debris preventing air flow to the radiator Hydraulic Hand Brake System CHECKINGBLEEDING
The hydraulic brake system has been filled and bled at the factoryTo check andor bleed the hydraulic brake system, use the
following procedure1With the master cylinder in level position, check the fluid levelIt must be above the minimum line and
below the maximum lineFig2-90 green light will illuminate when the transmission is in neutral and the ignition switch is
onThe light will go out when shifted into any gear other than neutral An orange light will illuminate when the transmission