2001 Arctic Cat ATVs factory service and repair manual, Page 48Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 48

ADJUSTING Fig2-101 To adjust (set up) the mechanical brake, use the following procedure1Loosen the right-hand jam nut (wheel-side
properly 6If the rear cable adjustment is inadequate to attain the proper brake pedal arm free-play gap, make adjustment
at the front cable adjuster jam nuts ! CAUTION If adjusting the rear cable at both ends does not attain proper brake pedal
arm free-play, the brake pads must be replacedMEASURINGREPLACING BRAKE PADS Removing 1Support the ATV on suitable stand2Remove
the right rear wheel and account for the cap screws3Loosen the rear cable adjuster jam nuts; then remove the cap screws securing
the mechanical brake to the axle housing4Remove the brake pads from the caliperInspecting and Measuring NOTE: At this point,
there should be 3.2 mm (18 in free-play gap between the brake pedal arm and the brake pedal bracket 1Inspect the pads for