2001 Arctic Cat ATVs factory service and repair manual, Page 103Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 103

Fig3-227 Fig3-229 NOTE: At this point, oil the camshaft bearings, cam lobes, and the three seating journals on the cylinder
down (toward the piston)CCamshaft alignment marks parallel to the valve cover mating surfaceDRecessed side of the sprocket
directed toward the cam lobesECamshaft alignment pin and sprocket alignment hole (smallest) are aligned NOTE: Note the position
of the alignment marks on the end of the camshaftThey must be parallel with the valve cover mating surfaceIf rotating the
camshaft is necessary for alignment, do not allow the chain and sprocket to rotate and be sure the cam lobes end up in the
down position ! CAUTION If any of the above factors are not as stated, go back to step 13 and carefully proceed 15Place the