2001 Arctic Cat ATVs factory service and repair manual, Page 105Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 105

Fig3-237 Fig3-239 22Rotate the crankshaft until the second cap screw securing the sprocket to the camshaft can be installed;
of any with rubber washers; then install the remaining cap screwsTighten only until snugFig3-240 28In crisscross pattern
starting from the center and working outward, tighten the cap screws to kg-m (7 ft-lb)CC407D 25Apply thin coat of Three Bond
Sealant (pn 0636-070) to the mating surface of the valve cover 29Adjust valvetappet clearance using the following procedureNOTE:
Use Valve Gap Adjuster (pn 0444-092) for this procedure ATurn the engine over until the piston reaches top dead center on
the compression strokeBPlace the valve adjuster onto the jam nut securing the tappet adjuster screw; then rotate the valve
adjuster dial clockwise until the end is seated in the tappet adjuster screwCWhile holding the valve adjuster dial in place,