2001 Arctic Cat ATVs factory service and repair manual, Page 120Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 120

2Remove the flange nut securing the spacer to the crankshaft; then remove the spacerFig3-310 Fig3-312 CC512DA BMagneto Rotor
rotor puller adapterFig3-313 4While continuously tapping in on the shift shaft, remove the left-side cover wstator assemblyAccount
for gasket and two alignment pinsNOTE: Inspect the inside of the left-side cover for any shaft washers (W) and spacers (S)
that may have come off with the coverMake sure they are returned to their respective shaftsAlso, make sure the alignment
pins (P) are in place Fig3-314 6Using the Magneto Rotor Remover (pn 0444-008), remove the rotor assembly from the crankshaftAccount