2001 Arctic Cat ATVs factory service and repair manual, Page 137Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 137

Fig3-403 Fig3-405 NOTE: When removing the crank balancer assembly, rotate the crankshaft counterweight away from the crank
the shaft into position with proper shims, slide the gear onto the shaft, and secure with new nut tightened to 10 kg-m (72
ft-lb)Fig3-406 + AT THIS POINT To service crankshaft assembly, see Servicing nt rankcase om ponents in this sub-section !
CAUTION Do not remove the remaining output shaft assembly unless absolutely necessaryIf the shaft is removed, the shaft nut
must be replaced wi new one and the shaf must be re-shimmed 12To remove the output shaft, remove the nut, slide the gear