2001 Arctic Cat ATVs factory service and repair manual, Page 141Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 141

3From the left side, install the three case half mm cap screws; then tighten only until snugNOTE: Rotate the shafts back
pattern, tighten the mm cap screws until the halves are correctly joined; then tighten to 2-2.4 kg-m (14.5-17 ft-lb)CC097D
5From the left side, install the seven case half mm cap screws; then tighten only until snugNOTE: Rotate the shafts back
and forth to ensure no binding or sticking occurs NOTE: Rotate the shafts back and forth to ensure no binding or sticking
occurs 8In crisscrosscase-to-case pattern, tighten the mm cap screws to 0.9-1.3 kg-m (6.5-9.5 ft-lb)NOTE: Rotate the shafts
back and forth to ensure no binding or sticking occurs + AT THIS POINT After completing center crankcase components, proceed