2001 Arctic Cat ATVs factory service and repair manual, Page 150Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 150

Fig3-473 Fig3-476 11Place the starter clutch gear assemlby onto the crankshaft; then place the key into its notchFig3-474
must precede this procedure 14Place the gasket and left-side cover into position on the crankcaseNOTE: It may be necessary
to push or pull the shift shaft to establish covercrankcase matingCC332D 12Place the magneto rotor into position on the crankshaft;
then install the magneto nut on the crankshaft and tighten until the rotor is properly seatedTighten to 16 kg-m (116 ft-lb)