2001 Arctic Cat ATVs factory service and repair manual, Page 156Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 156

+ Click Here Back Fig3-506 NOTE: Position the shift lever part way onto the splines and verify the subtransmission is in
the shift lever assembly the rest of the way onto the shift shaftSecure with the outer circlip making sure the sharp side
of the circlip faces away from the HiLow-range leverFig3-510 Fig3-508 28Place the starter cup into position on the crankshaft
making sure new, lubricated O-ring is inside the cupTighten the flange nut to 3.5 kg-m (25 ft-lb)Fig3-511 26Install the inside
circlip onto the HiLow range shift shaft with the sharp side of the circlip facing the engine; then place the shift lever