2001 Arctic Cat ATVs factory service and repair manual, Page 157Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 157

29Place the gasket and recoil starter assembly into position on the left-side cover; then tighten four cap screws to 0.8
6Water Hose Union 7Cap Screw 8O-Ring ATV-1024 ! CAUTION 0732-301 NOTE: If the piston rings were removed, install them in
this sequence Incorrect installation of the piston rings will result in engine damage AInstall thin oil ring, corrugated
oil ring, and thin oil ring in the bottom groove of the pistonStagger the gaps of the upper and lower thin rings 1Install
the piston on the connecting rod making sure there is circlip on each side and the open end of the circlip faces upwardsNOTE: