2001 Arctic Cat ATVs factory service and repair manual, Page 160Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 160

8Install the four cylinder head cap screws with copper washers (note the locations of the different-lengthed cap screws)Tighten
and the three seating journals on the cylinder 13With the cam lobes directed down (toward the piston), maneuver the camshaftsprocket
assembly through the chain and towards its seating position; then loop the chain over the sprocketFig3-528 Fig3-526 10In
crisscross pattern, tighten the four cylinder head cap screws to 3.8 kg-m (27.5 ft-lb); then tighten the mm nut to 2.5 kg-m
(18 ft-lb)Using crisscross pattern, tighten the four mm nuts to 1.1 kg-m (8 ft-lb)Tighten the two cylinder to crankcase nuts
securely NOTE: Note the position of the alignment marks on the end of the camshaftThey must be parallel with the valve cover