2001 Arctic Cat ATVs factory service and repair manual, Page 166Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 166

Fig3-554 Fig3-557 10Install the carburetor assembly and secure the intake manifold and air inlet bootFig3-555 14Route the
and tighten to 2.8 kg-m (20 ft-lb)Fig3-556 15Install both footrests; then secure the front of the fender flare with the existing
screws16Place the exhaust pipe into position inside the frame and connect to the muffler at the junctureNOTE: If the muffler
was removed, see Section 8 17Place the exhaust pipe with new grafoil gasket into position on the engine; install and tighten
the cap screws to 2.8 kg-m (20 ft-lb)18Install the front fenders and the front rack (see Section 8)19Install the gas tank