2001 Arctic Cat ATVs factory service and repair manual, Page 177Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 177

14Using the Piston-Pin Puller (pn 0144-003), remove the piston pinAccount for the opposite-side circlipRemove the pistonNOTE:
necessaryNote the AT THIS POINT information in each sub-sectionNOTE: The enginetransmission does not have to be removed from
the frame for this procedure ! CAUTION Do not allow the connecting rod to go down inside the crankcaseIf the rod is down
inside the crankcase and the crankshaft is rotated, severe damage will resultNOTE: If the existing rings will not be replaced
with new rings, note the location of each ring for proper installationWhen replacing with new rings, replace as complete
set onlyIf the piston rings must be removed, remove them in this sequenceFig3-611 Removing Left-Side Components ARecoil Starter
BShifter Assembly CSpeedometer Drive DCoverStator Assembly 1Remove the four cap screws securing the recoil starter assembly
to the left-side cover; then remove the recoil starterAccount for the gasket + AT THIS POINT ATV-1085 AStarting with the