2001 Arctic Cat ATVs factory service and repair manual, Page 191Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 191

2Lightly oil all bearings and grease all shafts in the right-side crankcaseFig3-685 6From the right side, install the five
to 2-2.4 kg-m (14.5-17 ft-lb)Fig3-688 3Using propane torch, heat the right-side crankshaft bearing until the oil begins to
smoke; then join the two crankcase halvesFig3-687 NOTE: Rotate the shafts back and forth to ensure no binding or sticking
occurs 10In crisscrosscase-to-case pattern, tighten the mm cap screws to 0.9-1.3 kg-m (6.5-9.5 ft-lb)NOTE: Rotate the shafts
back and forth to ensure no binding or sticking occurs 11Using liberal amount of grease, assemble the shift cam stoppers;
then install them into the top of the engineNOTE: The grease will hold the springs and cam stoppers in position while installing
the assemblies into the engine 4Using plastic mallet, lightly tap the case halves together until cap screws can be installed5From