2001 Arctic Cat ATVs factory service and repair manual, Page 195Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 195

17Pinch the V-belt together near its center and slide the spacer and movable drive face onto the shaftSecure the drive face
be removed from between the driven clutch faces 18Rotate the V-belt and clutches until the V-belt is flush with the top of
the driven clutch19Place the V-belt cover gasket into position; then install the cover and secure with the cap screws making
sure the different-lengthed cap screws are in their proper locationTighten the cap screws to 1.1 kg-m (8 ft-lb)Fig3-705 NOTE:
The sharp side of the snap ring should be facing outward 2Install the water pump driven gear alignment pin and the driven
gear (with the beveled side of the gear facing outward as noted in removing); then secure with the snap ringFig3-707 NOTE: