2001 Arctic Cat ATVs factory service and repair manual, Page 196Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 196

3Install the two starter gear shafts; then install the two starter gears (with the beveled side of each gear facing inward
coated with red Loctite #271)Tighten to 16 kg-m (116 ft-lb)5Lubricate the magneto cover gasket with fresh engine oil; then
place it into position on the two dowel pinsFig3-709 8Place the water pump into position and secure with two cap screwsTighten
securelyFig3-711 9Install the crossover tube on the water pump and cylinder head making sure the O-ring is properly positionedFig3-712