2001 Arctic Cat ATVs factory service and repair manual, Page 200Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 200

7Place the head gasket into position on the cylinderPlace the alignment pins into position; then place the head assembly
pattern, tighten the four mm nuts to 1.1 kg-m (8 ft-lb)Tighten the two cylinder to crankcase nuts securely11With the timing
inspection plug removed and the chain held tight, rotate the crankshaft until the piston is at top-dead-center12With the
alignment pin installed in the camshaft, loosely place the cam sprocket (with the recessed side facing the cam shaft lobes)
onto the camshaftAt this point, do not "seat" the sprocket onto the shaftFig3-729 9Loosely install the five cylinder head