2001 Arctic Cat ATVs factory service and repair manual, Page 217Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 217

Installing Piston Rings 1Install thin ring, corrugated ring, and thin ring in the bottom groove of the pistonStagger the
before assembly by continuing to move the cylinder head in figure eight motion until uniform bright metallic finish is attained
ATV-1085 ! CAUTION Water or parts-cleaning solvent must be used in conjunction with the wet-or-dry sandpaper or damage to
the sealing surface may resultFig3-803 2Install the middle and upper rings so the letter on the top surface of each ring
faces the dome of the pistonRotate the rings until the ring gaps are on directly opposite sides of the pistonFig3-802 726-306A
Fig3-804 ! CAUTION Incorrect installation of the piston rings will result in engine damageCYLINDER CYLINDER HEAD ASSEMBLY
NOTE: If the cylindercylinder head assembly cannot be trued, they must be replacedCleaningInspecting Cylinder Head ! CAUTION