2001 Arctic Cat ATVs factory service and repair manual, Page 218Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 218

Measuring Cylinder Head Distortion ! CAUTION Water or parts-cleaning solvent must be used in conjunction with the wet-or-dry
are found, repair the surface using cylinder hone (see Honing Cylinder in this sub-section)3Place the cylinder on the surface
plate covered with #400 grit wet-or-dry sandpaperUsing light pressure, move the cylinder in figure eight motionInspect the
sealing surface for any indication of high spotsA high spot can be noted by bright metallic finishCorrect any high spots
before assembly by continuing to move the cylinder in figure eight motion until uniform bright metallic finish is attained
1Using slide gauge and dial indicator or snap gauge, measure the cylinder bore diameter in three locations from top to bottom
and again from top to bottom at 90 from the first measurements for ota of six measurementsThe trueness (out-of-roundness)