2001 Arctic Cat ATVs factory service and repair manual, Page 224Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 224

Fig3-836 Cleaning and Inspecting NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is
injury 8Remove the protective cover from the starter handle and pull the rope out of the handle; then untie the knot in the
rope and remove the handleNOTE: Do not remove the spiral spring unless replacement is necessaryIt should be visually inspected
in place to save timeIf replacement is necessary, follow steps 9-10B606D 9Remove the spring from the housing by lifting the
spring end up and outHold the remainder of the spring with thumbs and alternately release each thumb to allow the spring
to gradually release from the housing10Unwind the rope from the reel and remove the rope 2Insert the rope through the hole
in the reel and tie knot in the end; then wrap the rope counterclockwise around the reel leaving approximately 50 cm (20
in of rope free of the reel3Apply low-temperature grease to the spring and hub4Thread the end of the rope through the guide
hole of the housing; then thread the rope through the handle and secure it with double knotInstall the protective cover into