2001 Arctic Cat ATVs factory service and repair manual, Page 225Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 225

Fig3-839 Fig3-842 6Install the ratchet making sure the end is properly installed on the reelFig3-840 9While pushing down
the rope from the notch and allow the rope to retract12Pull the rope out two or three times to check for correct tensionNOTE:
Increasing the rotations in step 11 will increase spring tension 13Place the gasket and recoil starter assembly into position
on the left-side cover noting the location of the single washer; then tighten the cap screws to 0.8 kg-m (6 ft-lb) 8Install