2001 Arctic Cat ATVs factory service and repair manual, Page 230Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 230

Backlash Measurement Under 0.05 mm (0.002 in At 0.05-0.33 mm (0.002-0.013 in Over 0.33 mm (0.013 in Shim Correction Decrease
pattern illustration, no correction is necessary 1If tooth contact pattern is comparable to an incorrect pattern, correct
tooth contact according to the following chartTooth Contact Contacts at Top Contacts at Root Shim Correction Decrease Shim
Thickness Increase Shim Thickness NOTE: To correct tooth contact, steps and (with NOTE) of "Correcting Backlash" must be
followed and the above "Tooth ContactShim Correction" chart must be consulted ! CAUTION After correcting tooth contact, backlash
must again be checked and corrected (if necessary)Continue the correcting backlashcorrecting tooth contact procedures until
they are both within tolerance valuesATV-0103 Fig3-858 CRANKSHAFT ASSEMBLY Measuring Connecting Rod (Small End Inside Diameter)
1Insert snap gauge into the upper connecting rod small end bore; then remove the gauge and measure it with micrometer ATV-0105