2001 Arctic Cat ATVs factory service and repair manual, Page 231Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 231

Fig3-860 Measuring Connecting Rod (Big End Width) 1Using calipers, measure the width of the connecting rod at the big-end
the indicator and push the small end of the connecting rod away from the dial indicator3Maximum deflection is mm (0.12 inMeasuring
Connecting Rod (Big End Side-to-Side) ATV-1074 3Zero the indicator and rotate the crankshaft slowly 1Push the lower end of
the connecting rod to one side of the crankshaft journal2Using feeler gauge, measure the gap between the connecting rod and
crankshaft journalFig3-861 ! CAUTION Care should be taken to support the connecting rod when rotating the crankshaft 4Maximum
runout is 0.05 mm (0.002 in for the left side and 0.08 mm (0.003 in for the right side on the 250300 cc, 0.05 mm (0.002 in
for both sides on the 400 cc, and 0.08 mm (0.003 in for both sides on the 500 ccNOTE: Proceed to check runout on the other
end of the crankshaft by positioning the indicator contact at point and following steps 2-4Measuring Crankshaft (Web-to-Web)