2001 Arctic Cat ATVs factory service and repair manual, Page 243Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 243

Fig3-923 6On the 400500 cc, install the 2nd drive gear and 2nd drive washer onto the countershaftFig3-926 Fig3-924 NOTE:
driven gear and account for the washer, bushing, and bearing4Remove the low driven gear washer and lock washers; then remove
the low driven gearAccount for the bushing and bearing5Remove the washer; then remove the snap ring securing the sliding
dogRemove the sliding dog6Remove the high driven gear snap ring; then remove the high driven gearAccount for the washer,
bushing, and bearing 5On the 250300 cc, press the 2nd drive gear onto the countershaft leaving an 0.25 mm (0.010 in gap between
the 2nd and 5th drive gearsNOTE: When pressing the 2nd drive gear onto the countershaft, the inside of the gear must be oil
free; then apply thin, even coat of green Loctite #620 being careful not to get Loctite on the other gears ! CAUTION Pressing