2001 Arctic Cat ATVs factory service and repair manual, Page 244Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 244

Assembling Fig3-927 KEY 1Washer 2Washer 3Countershaft 4Low Driven Gear 5Bushing 6High Driven Gear 7Sliding Dog 8Drive Gear
washers and washer onto the shaft4Place the reverse driven gear onto the countershaft making sure the bearing, bushing, and
washer are properly positioned; then secure with the snap ring5Place the reverse gear dog onto the countershaft; then secure
with the snap ring6Place drive gear #2 onto the countershaftNOTEhen nstall ing the countershaft assembly, account for the
washer on each end of the shaftDRIVEN GEAR (400500 cc) Disassembling Fig3-928 2Note the position of the alignment marks for
installation; then remove the driven gear with inner raceAccount for three pins and six springsFig3-929 1Remove the circlip