2001 Arctic Cat ATVs factory service and repair manual, Page 255Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 255

NOTE: Check float arm height by inverting the carburetor freeing the float arm; then measuring with caliper the height when
snap the E-clip into the proper groove at the top of the jet needle; then with the E-clip in position, slide the plastic
washer up from the bottom of the jet needle and tight against the E-clipFig4-37 13 mm 14 mm 0.5 in0.6 in 5Place the float
chamber into place making sure the O-ring is properly seated; then secure with the four Phillips-head screwsNote the position