2001 Arctic Cat ATVs factory service and repair manual, Page 263Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 263

5Place the float assembly (with float needle valve) into position and secure to the carburetor with the float pinFig4-79
with the needle valveFloat arm height should be 17 mm (0.67 in ! CAUTION It is important to press down on the primer housing
until it contacts the carburetor to make sure the diaphragm lip is properly seated in the groove in the carburetorIf the
diaphragm is not properly seated, leakage will occur 6Place the float chamber into position making sure the O-ring is properly
positioned; then secure with the Phillips-head screwsFig4-80 8Place the jet needle, spring seat, and spring into the vacuum