2001 Arctic Cat ATVs factory service and repair manual, Page 266Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 266

1Place all metallic components in wire basket and submerge in carburetor cleaner2Soak for 30 minutes; then rinse with fresh
damageNOTE: If the pilot jet is obstructed, the mixture will be extremely lean at idle and part-throttle operation 11Inspect
the plunger assemblystarter valve and seat for wear or damageCC531 12Inspect the carburetor mounting flange for damage and
tightness 10Turn the gas tank valve to the ON position Cleaning and Inspecting Carburetor NOTE: Whenever part is worn excessively,
cracked, or damaged in any way, replacement is necessary Throttle Cable Free-Play 1Check throttle cable free-play at the
lever; free-play should be 3-6 mm (1814 in2To adjust, slide the rubber boot away from the adjuster located near the throttle
leverLoosen the jam nut and rotate the adjuster in the appropriate direction until proper free-play is attainedTighten the
jam nut against the adjuster; then slide the rubber boot over the adjuster ! WARNING When drying components with compressed