2001 Arctic Cat ATVs factory service and repair manual, Page 277Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 277

INSPECTING HosesThermostat REMOVING NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement
deterioration, cracks, and wearNOTE: All coolant hoses and clamps should be replaced every four years or 4000 milesCC334D
INSTALLING 3Remove the clamps securing the upper coolant hose to the thermostat housing and to the radiator; then remove
the upper hoseFig4-127 1Place the thermostat and O-ring into the thermostat housing; then secure the thermostat housing to
the cylinder head with the two cap screws2Install the crossover coolant hose onto the water pump and engine water inletSecure
with the two hose clamps3Slide the upper hose onto the thermostat housing and radiatorSecure with the two hose clampsFig4-128
4Remove the clamps securing the crossover coolant hose to the water pump and to the engine water inlet5Remove the two cap