2001 Arctic Cat ATVs factory service and repair manual, Page 282Get this manual

4Using small screwdriver, pry up and remove the ceramic seal from the impellershaft; then remove the seal seatFig4-145 Fig4-147
If the protective cloth is not used and the sealseat assembly is touched, permanent damage to the assembly will occur and
replacement will be necessaryCC775 CLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in
any way, replacement is necessary Fig4-148 1Clean all oil-pump components in cleaning solvent2Inspect the impellershaft for
corrosion or damageASSEMBLING 1Place the new oil seal into the bearing housing; then using seal driver, gently tap the seal