2001 Arctic Cat ATVs factory service and repair manual, Page 283Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 283

Fig4-149 Fig4-151 NOTE: Make sure the E-ring is fully seated and the impeller rotates freely 2Connect the two coolant hoses
installed) into position on the housing; then loosely secure with the two Phillips-head cap screwsINSTALLING 3From inside
the left-front wheel-well, secure the fender to the frame with the two torx-head cap screwsTighten securelyFig4-153 1Secure
the water pump to the engine with the two cap screws tightened securely; then tighten the two Phillips-head cap screws securelyFig4-150
4Place the footrest into position on the frame and loosely secure with four cap screws and nuts; then secure the front and