2001 Arctic Cat ATVs factory service and repair manual, Page 290Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 290

3When the brake pedal is depressed, the meter must show less than ohmNOTE: If the meter shows more than ohm of istanceroubleshoot
Section 8)NOTE: The ignition switch must be in the ON positionVOLTAGE (Wiring Harness Connector) 1Set the meter selector
to the D.CVoltage position2Connect the red tester lead to the orange wire; then connect the black tester lead to groundFig5-7
! CAUTION Always disconnect the battery when performing resistance tests to avoid damaging the multimeter 1Set the meter
selector to the OHMS position2Connect the red tester lead to one black wire; then connect the black tester lead to the other
black wireFig5-6 3The meter must show battery voltageNOTE: If the meter shows no battery voltage, troubleshoot the battery,