2001 Arctic Cat ATVs factory service and repair manual, Page 291Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 291

RESISTANCE (Brakelight Switch Connector) ! CAUTION Always disconnect the battery when performing resistance tests to avoid
cc) 3When the lever is compressed, the meter must show less than ohmNOTE: If the meter shows more than ohm of istancetroubleshoot
or replace the switchcomponent, the connector, or the switch wiring harness To access the connector (located directly behind
the fan), the front rack and front fenders must be removed (see Section 8)NOTE: The ignition switch must be in the ON positionVOLTAGE
(Main Harness Connector to Fan Motor) Oil Temperature Switch (250300 cc) 1Connect the meter leads (selector in the OHMS position)
to the temperature switch contacts2Suspend the temperature switch and thermometer in container of oil; then heat the oilNOTE:
Neither the temperature switch nor the thermometer should be allowed to touch the bottom of the container or inaccurate readings
will occurU se rs sw ch and thermometer 1Set the meter selector to the D.CVoltage position2Connect the red tester lead to