2001 Arctic Cat ATVs factory service and repair manual, Page 292Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 292

NOTE: If the meter shows no battery voltage, troubleshoot the battery, fuse, motor, or the main wiring harnessNOTE: If the
the fuse box2Set the meter selector to the D.CVoltage position3Connect the black tester lead to ground4Using the red tester
lead, contact each end of the fuse holder connector terminals individuallyFig5-11 250300cc 3The meter must show less than
ohmNOTE: If the meter shows more than ohm of istancetroubleshoot or replace the switchcomponent, the connector, or the switch
wiring harnessNOTE: To determine if the fan motor is good, connect the blue wire from the fan connector to 12 volt D.Cpower
supply; then connect the black wire from the fan connector to groundThe fan should operateCH095D 400500 cc ! CAUTION Care
should be taken to keep clear of the fan bladesAR655D 5The meter must show battery voltage from one side of the connector
terminal endsNOTE: Battery voltage will be indicated from only one side of the fuse holder connector terminal; the other