2001 Arctic Cat ATVs factory service and repair manual, Page 293Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 293

NOTE: When testing the HI fuse holder, the headlight dimmer switch must be in the HI position; when testing the LO fuse holder,
then disconnect the connector from the main wiring harnessNOTE: For testing purposes, the Indicator Lights connector must
also be disconnected to access the power source terminalFig5-15 High Beam Power Source Reverse 1Set the meter selector to
the OHMS position2Connect the red tester lead to one spade end of the fuse; then connect the black tester lead to the other
spade endFig5-13 3The meter must show less than ohm resistanceIf the meter reads open, replace the fuseNOTE: Make sure the
fuses are returned to their proper position according to amperageRefer to the fuse block cover for fuse placementGround Temperature
Neutral Gear Position Lights (300 cc 4x4400500 cc Manual Transmission) INDICATOR LIGHTS = Male TerminalFemale Terminal NOTE: