2001 Arctic Cat ATVs factory service and repair manual, Page 294Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 294

FIRST GEAR 1Connect the jumper positive wire to the power source terminal on the indicator light connector2Connect the jumper
from the switch) ! CAUTION Always disconnect the battery when performing resistance tests to avoid damaging the multimeterNEUTRAL
POSITION NOTE: For these tests, the meter selector should be set to the OHMS position 1Connect the jumper positive wire to
the power source terminal on the indicator light connector2Connect the jumper ground wire to the third gear terminal on the
gear position light connector3The third gear position indicator light should illuminateFOURTH GEAR 1Connect the jumper positive
wire to the power source terminal on the indicator light connector2Connect the jumper ground wire to the fourth gear terminal
on the gear position light connector3The fourth gear position indicator light should illuminateFIFTH GEAR 1Connect the red
tester lead to the redblack wire; connect the black tester lead to ground2With the shifter in the neutral position, the meter