2001 Arctic Cat ATVs factory service and repair manual, Page 295Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 295

FOURTH GEAR RESISTANCE 1Connect the red tester lead to the yellowblue wire; connect the black tester lead to ground2With
must be removed (see Section 8)On the 400500 cc, the ignition coil is on top of the engineTo access the coil, the seat and
gas tank (see Section 4) must be removedFig5-17 VOLTAGE (Primary Side) NOTE: The ignition switch must be in the ON position;
the emergency stop switch must be in the RUN positionAlso, the whiteblue wire must be disconnected from the coil400500 cc
1Set the meter selector to the D.CVoltage position2Connect the black tester lead to the whiteblue wire; then connect the
red tester lead to ground3The meter must show 31V 204With the tester leads connected, depress the starter button5The meter
must show 130V 20NOTE: If the voltage is not as specified in one or both of the above tests, inspect the main wiring harness,
connectors, sourcecharge coil, magneto rotor and magnets, magneto rotor key, or the CDI unitAR615D 2The meter must show 0.1-