2001 Arctic Cat ATVs factory service and repair manual, Page 296Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 296

NOTE: If the meter does not read as specified, replace the spark plug cap250300 cc Indicator Lights The Indicator Lights
from the instrument pod; then cut the cable tie securing the instrument pod wiring to the steering post3Push the instrument
pod wiring with light bar downward to access the indicator light connector; then disconnect the connector from the main wiring
harnessNOTE: For these tests, 12-volt power supply "jumper" should be used to supply powerTEMPERATURE LIGHT 1Connect the
red tester lead to one end of the cap; then connect the black tester lead to the other end of the capFig5-20 1Connect the
jumper positive wire to the power source terminal on the indicator light connector2Connect the jumper ground wire to the
temperature terminal on the indicator light connector3The temperature warning indicator light should illuminateAR603D 2The