2001 Arctic Cat ATVs factory service and repair manual, Page 297Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 297

NEUTRAL POSITION LIGHT 1Connect the jumper positive wire to the power source terminal on the indicator light connector2Connect
the jumper positive wire to the power source terminal on the indicator light connector2Connect the jumper ground wire to
the reverse terminal on the indicator light connector3The reverse position indicator light should illuminateHI BEAM LIGHT
1Connect the jumper positive wire to the high beam terminal on the indicator light connector2Connect the jumper ground wire
to the female terminal on the indicator light connector3The HI beam indicator light should illuminateNOTE: If light fails
to illuminate in any one of the indicator light tests, the connector, wiring harness, or bulb must be replaced 1Set the meter
selector to the D.CVoltage position2Remove the violet water temperature switch wire connector from the switch (on the left
side of the engine below the water hose) and ground it to the engine3Connect the red tester lead to the redblack wire from
the fan temperature switch; then connect the black tester lead to the violet wire from the water temperature switch4The meter