2001 Arctic Cat ATVs factory service and repair manual, Page 298Get this manual

2Connect the red tester lead to the redblack wire; then connect the black tester lead to the blue wire3The meter must show
front fenders must be removed (see Section 8)NOTE: These tests should be made on the top side of the connector 1Set the meter
selector to the D.CVoltage position2Connect the red meter lead to the red wire; then connect the black meter lead to ground3Meter
must show battery voltageNOTE: If the meter shows no battery voltage, troubleshoot the battery or the main wiring harnessRESISTANCE
! CAUTION Always disconnect the battery when performing resistance tests to avoid damaging the multimeterRESISTANCE (HI Beam)
1Set the meter selector to the OHMS position ! CAUTION Always disconnect the battery when performing resistance tests to
avoid damaging the multimeterNOTE: Perform this test on the upper side of the connector 2Connect the red tester lead to the
yellow wire; then connect the black tester lead to the gray wire3With the dimmer switch in the HI position, the meter must