2001 Arctic Cat ATVs factory service and repair manual, Page 299Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 299

2Connect the red tester lead to the orangewhite wire; then connect the black tester lead to the yellowgreen wire3With the
5000 RPM (with the headlights on), the meter must show 14-15.5 D.Cvolts 1Set the meter selector to the OHMS position2Connect
the red tester lead to the orange wire; then connect the black tester lead to the orangewhite wire3With the switch in the
OFF position, the meter must show an open circuit4With the switch in the RUN position, the meter must show less than ohmNOTE:
If the meter shows more than ohm of istancetroubleshoot or replace the switchcomponent, the connector, or the switch wiring
harnessRESISTANCE (Reverse Override) ! CAUTION Do not run the engine at high RPM for more than 10 secondsNOTE: If voltage
is lower than specified, test charging coilsno loadVOLTAGE (Charging CoilsNo Load) The connector is the black and white one
on the right side of the engine just above the brake cable adjusterNOTE: Test the connector that comes from the engine The
connector is the four-prong white one in front of the steering postTo access the connector, the front rack and front fenders