2001 Arctic Cat ATVs factory service and repair manual, Page 300Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 300

3With the engine running at constant 5000 RPM, all three black wire tests must show 60 A.Cvolts ! CAUTION Do not run the
when performing resistance tests to avoid damaging the multimeter NOTE: If the meter shows other than specified in any resistance
test, replace the stator assembly 1Set the meter selector to OHMS position2Test between the three yellow wires (250300 cc)
for total of three tests or the three black wires (400500 cc) for total of three testsFig5-23 Starter Motor REMOVINGDISASSEMBLING
1Disconnect the battery ! WARNING Always disconnect the negative battery cable from the battery first; then disconnect the
positive cable 2Remove the nut securing the positive cable to the starter; then remove the cable from the starterFig5-24
250300 cc 3In all tests, the meter must show 0.11.0 ohmRESISTANCE (Trigger Coil) ! CAUTION Always disconnect the battery
when performing resistance tests to avoid damaging the multimeter 1Set the meter selector to the OHMS position2On the 250300