2001 Arctic Cat ATVs factory service and repair manual, Page 306Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 306

NOTE: If the meter showed battery voltage but the starter did not operate or operated slowly, inspect battery voltage (at
be in the ON position, the emergency stop switch in the RUN position, the reverse lever (on manual transmission models) in
the FORWARD position, and the shift lever (on automatic transmission model) in the NEUTRAL position 1Disconnect the battery;
then verify that the ignition fuse is goodDisconnect all wires from the solenoid2Set the meter selector to the OHMS position3Connect
the tester leads to each of the heavy posts of the solenoid4The meter must show an open circuitFig5-51 1Set the meter selector
to the D.CVoltage position2Connect the red tester lead to the starter terminal; connect the black tester lead to ground3With
the starter button depressed, the meter must show battery voltage and the starter motor should operateFig5-50 NOTE: Leave
the tester leads connected to the solenoid posts for the following procedureNOTE: An external 12-volt power supply "jumper"