2001 Arctic Cat ATVs factory service and repair manual, Page 307Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 307

5Connect the power supply leads to each small terminal of the solenoidThere should be an audible "click" from the relay,
when performing resistance tests to avoid damaging the multimeter 1Disconnect the battery; then verify that the starter relay
30-amp fuse is good2Set the meter selector to the OHMS position3Connect the red tester lead to terminal #1; then connect
the black tester to terminal #24The meter must show an open circuitNOTE: Leave the tester leads connected to the terminals
for the following procedureNOTE: An external 12-volt power supply "jumper" (positive and negative connections) must be used
for this testAlso, it is very important that the meter leads and power supply connections are made to the appropriate terminals
of the relay or damage to the multimeter will result 5Connect the power supply (positive) to terminal #3; then connect the
power supply (negative) to terminal #4There should be an audible "click" from the relay, and the meter must show less than