2001 Arctic Cat ATVs factory service and repair manual, Page 308Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 308

6With the 12-volt power supply still connected, then connect the red tester lead to the heavy battery cable terminal; connect
specification), substitute another CDI unit to verify the suspected one is defectiveRESISTANCE RegulatorRectifier (250300
cc) ! CAUTION Always disconnect the battery when performing resistance tests to avoid damaging the multimeter The regulatorrectifier
is located near the batteryRESISTANCE 1Set the meter selector to the OHMS position2Test each combination as found in the
following chartWrite down each test value for each test for comparison with the value in the chartNOTE: As an example, connect
the red tester lead to terminal #2; then connect the black tester lead to terminal #3The meter must show 20-100 k-ohms !
CAUTION Always disconnect the battery when performing resistance tests to avoid damaging the multimeter 1Set the meter selector
to the OHMS position2Test each combination as found in the following chartNOTE: As an example, connect the red tester lead