2001 Arctic Cat ATVs factory service and repair manual, Page 311Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 311

Neutral Start Relay The connector is the white 4-prong one near the batteryVOLTAGE (Connector) NOTE: The ignition switch
the "click" was heard in the power supply test), the relay must be replacedRESISTANCE (RelayBrass Terminals) 4With the black
tester lead still connected to ground, connect the red tester lead to the yellowgreen wire5Depress the starter buttonThe
meter must show battery voltageNOTE: If the meter shows no battery voltage, inspect fuses, wiring harness, connectors, and
switchesRESISTANCE (RelayCopper Terminals) ! CAUTION Always disconnect the battery when performing resistance tests to avoid
damaging the multimeterNOTE: The external power supply will not be used for this test ! CAUTION Always disconnect the battery
when performing resistance tests to avoid damaging the multimeterNOTE: An external 12-volt power supply "jumper" (positive
and negative connections) must be used for this testAlso, it is very important that the meter leads and power supply connections