2001 Arctic Cat ATVs factory service and repair manual, Page 328Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 328

2While holding the differential case with the pinion shaft hole upward, insert the pinion shaft (with the alignment hole
then using the existing shim as guide, adjust backlash by referring to the Shim Chart 3Install the pinion shaft pinFig6-70
SHIM CHART pn 3423-294 3423-295 3423-296 Thickness 0.8 mm0.0315 in 1.0 mm (0.0394 in 1.2 mm (0.0472 in 5Position the shims
on the left-side gear; then install the left-side gear into the hubPlace the hub assembly into the differential gear case
4Measure gear teeth backlash using the following procedureAInsert 7.6 cm (3 in section of 0.5 mm (0.020 in solder between