2001 Arctic Cat ATVs factory service and repair manual, Page 335Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 335

Fig6-108 EMaximum runout must be within range of 0.00-0.05 mm (0.00-0.002 inNOTE: If the backlash range is not within tolerance,
procedureAMeasure the width of suitable straightedge; then record the width measurementFig6-112 BUsing suitable cylindrical
stand (such as bearing driver or roll of duct tape) as work fixture, place the differential housing onto surface plateCMount
magnetic-based dial indicator on the surface plate; then place the contact point on one ear of the drive bevel gear flangeFig6-110