2001 Arctic Cat ATVs factory service and repair manual, Page 336Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 336

CAfter subtracting the width of the straightedge, record the driven bevel gear depthDUsing calipers, measure the height of
bearing race height measurement (from step H) is 0.158 in the difference is 0.037 inand an 0.020 inshim and an 0.016 inshim
must be used to bring the clearance within tolerance 44Check gear tooth contact using the following procedureAClean the gear
teeth of old oil and grease residueAF874D BApply thin, even coat of machinist-layout dye to several teeth of the gearCRotate
the gear several revolutions in both directionsDExamine the tooth contact pattern in the dye and compare the pattern to the
illustrationsFig6-117 EMeasure the width of suitable straightedge; then record the width measurementFig6-115 FUsing calipers,